Bostitch SFC500L Air Compressor Manual

The Bostitch SFC500L is a compact and powerful air compressor designed for various applications including inflation, nailing, and other pneumatic tools. It features a lightweight design, a 6-gallon tank, and a maximum pressure of 150 PSI. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, 150 PSI maximum pressure, oil-free pump, lightweight design, and easy-to-read pressure gauge.

Feature	Description
Oil-Free Pump	Requires no maintenance and provides clean air.
6-Gallon Tank	Provides ample air supply for various tasks.
150 PSI Maximum Pressure	Delivers high pressure for efficient operation.
Lightweight Design	Easy to transport and store.
Pressure Gauge	Allows for easy monitoring of air pressure.

Installation

Unpack and inspect the compressor. Place it on a stable surface away from moisture.

Connect the air hose: Ensure it is securely attached to the compressor outlet.
Plug into a power source: Use a grounded outlet to prevent electrical hazards.
Check for leaks: Turn on the compressor and inspect for any air leaks.

WARNING! Always ensure the compressor is off and unplugged before making any connections.

First-Time Setup

Power on the compressor and allow it to build pressure before use.

Set the desired pressure: Adjust the regulator to your required PSI.
Test the compressor: Use a pneumatic tool to ensure proper operation.

CAUTION! Do not exceed the maximum pressure rating of your tools.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Power Source: 120V AC.
Weight: 30 lbs.
Pump Type: Oil-free.
Noise Level: 78 dBA.

Controls and Settings

Access the pressure regulator and gauge located on the front panel. Adjust the pressure settings as needed for your application.

Safety Features: Includes a thermal overload protection and a safety valve.

Connecting Devices

Ensure the compressor is off before connecting any tools.

Connect the air hose to the compressor outlet.
Attach the desired pneumatic tool to the other end of the hose.
Turn on the compressor and set the desired pressure.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

To operate, turn on the compressor and allow it to build pressure. Use the air supply for your tools as needed.

Monitor the pressure gauge during operation.
Turn off the compressor when finished.

WARNING! Do not operate the compressor in wet conditions.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check and replace the air filter as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor. Always wear appropriate personal protective equipment.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor does not start	Power source issue	Check power cord and outlet.
Low pressure	Leak in hose	Inspect and replace damaged hoses.
Excessive noise	Loose parts	Tighten all screws and fittings.
Tank does not fill	Faulty pressure switch	Replace pressure switch if necessary.

Service: For support, contact Bostitch customer service.