Bostitch CWC100 Air Compressor Manual

The Bostitch CWC100 is a compact and portable air compressor designed for a variety of tasks, including inflation, nailing, and stapling. It features a 1-gallon tank, a maximum pressure of 100 PSI, and a lightweight design for easy transport. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 1-gallon tank, 100 PSI maximum pressure, oil-free pump, lightweight design, and easy-to-read pressure gauge.

Feature	Description
1-Gallon Tank	Compact size for portability and easy storage
100 PSI Maximum Pressure	Suitable for a variety of inflation and nailing tasks
Oil-Free Pump	Requires less maintenance and provides cleaner air
Pressure Gauge	Easy monitoring of air pressure
Lightweight Design	Easy to carry and transport

Installation

Unpack and inspect the compressor. Place it on a stable surface away from moisture.

Connect the air hose: Ensure the compressor is off before connecting.
Check the power supply: Use a grounded outlet to avoid electrical hazards.
Ensure all connections are secure before turning on the compressor.

WARNING! Always check for leaks before use. Ensure the area is well-ventilated.

First-Time Setup

Power on the compressor; allow it to build pressure before use.

Set the desired pressure using the regulator.
Connect your tool or hose to the air outlet.
Turn on the compressor and monitor the pressure gauge.

CAUTION! Do not exceed the maximum pressure rating of your tools.

Specifications

Tank Size: 1 gallon.
Maximum Pressure: 100 PSI.
Power Source: 120V AC.
Weight: Approximately 20 lbs.
Pump Type: Oil-free.
Noise Level: 68 dBA.
Dimensions: 15 x 15 x 15 inches.

Controls and Settings

Access the pressure regulator and gauge for adjusting the output pressure. The on/off switch is located on the side of the unit.

Tip: Always adjust the pressure before connecting your tools.

Connecting Devices

Ensure the compressor is off before connecting any devices.

Match the air hose to the appropriate outlet.
Securely fasten the connections to prevent air leaks.
Turn on the compressor and check for proper operation.

Tip: Use quick-connect fittings for easier tool changes.

Operating the Compressor

To operate, turn on the compressor and allow it to reach the desired pressure. Use the air for inflation or powering tools as needed.

Monitor the pressure gauge during operation.
Turn off the compressor when finished and disconnect tools.

WARNING! Do not leave the compressor running unattended.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check and replace air filters as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Always follow safety guidelines when operating the compressor. Wear appropriate personal protective equipment and ensure the work area is clear of hazards.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor does not start	No power supply	Check power cord and outlet.
Low pressure	Leak in hose or connections	Inspect and tighten connections.
Excessive noise	Worn components	Inspect for wear; replace if necessary.
Tank does not fill	Faulty pressure switch	Contact customer service for assistance.

Service: For support, contact Bostitch customer service.