Bostitch CAP60P-OF Air Compressor Manual

The Bostitch CAP60P-OF is a powerful and efficient air compressor designed for both professional and DIY use. With a 6-gallon tank and a maximum pressure of 150 PSI, it provides reliable performance for a variety of applications including nail guns, air tools, and inflation tasks. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, 150 PSI maximum pressure, oil-free pump, lightweight design, and easy-to-read pressure gauges.

Feature	Description
Oil-Free Pump	Requires no maintenance and provides clean air.
6-Gallon Tank	Offers a good balance of portability and performance.
150 PSI Maximum Pressure	Suitable for a variety of air tools and applications.
Lightweight Design	Easy to transport and store.
Easy-to-Read Gauges	Provides clear visibility of pressure levels.

Installation

Unpack and inspect the compressor. Place it on a stable surface away from moisture.

Connect the air hose: Ensure it is securely attached to the compressor outlet.
Plug into a grounded outlet: Use a suitable extension cord if necessary.
Check for leaks: Turn on the compressor and inspect connections.

WARNING! Ensure the compressor is off and unplugged during setup.

First-Time Setup

Power on the compressor; allow it to build pressure before use.

Set the desired pressure: Adjust the regulator to the required PSI.
Test the compressor: Connect an air tool and ensure proper operation.

CAUTION! Do not exceed the maximum pressure rating.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Pump Type: Oil-free.
Weight: Approximately 30 lbs.
Dimensions: 24 x 18 x 18 inches.
Power Source: 120V AC.
Noise Level: 78 dBA.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel.

Pressure Regulator: Adjusts the output pressure for connected tools.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

Connect air tools using a compatible air hose.

Ensure the compressor is off before connecting.
Match the hose to the tool's inlet.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

Follow these steps to operate the compressor safely and effectively.

Turn on the compressor and allow it to reach the set pressure.
Connect your air tool and begin operation.
Monitor pressure levels and adjust as necessary.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check and replace air filters as needed.
Inspect hoses and connections for wear and tear.

Safety Information

Always follow safety precautions when operating the compressor.

Wear appropriate personal protective equipment (PPE).
Keep the compressor in a well-ventilated area.
Do not operate in wet conditions.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor does not start	Power supply issue	Check the power cord and outlet.
Low pressure	Leak in the system	Inspect hoses and connections for leaks.
Excessive noise	Worn components	Inspect for loose parts and replace as necessary.
Tank does not fill	Faulty pressure switch	Replace the pressure switch if needed.

Reset: Unplug and plug back in to reset the compressor.

Service: For assistance, contact Bostitch customer support.