Bostitch CAP2080WB Air Compressor Manual

The Bostitch CAP2080WB is a powerful 2.0 HP air compressor designed for both professional and DIY use. It features a 6-gallon pancake tank that provides a stable base and reduces the risk of tipping. The compressor is equipped with a high-efficiency motor that allows for quick recovery time and a maximum pressure of 150 PSI. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon pancake tank, high-efficiency motor, quick recovery time, maximum pressure of 150 PSI, and lightweight design for easy portability.

Feature	Description
6-Gallon Tank	Provides a stable base and reduces tipping risk
150 PSI Maximum Pressure	Allows for a wide range of applications
High-Efficiency Motor	Ensures quick recovery time
Lightweight Design	Easy to transport and maneuver
Oil-Free Pump	Requires less maintenance and provides clean air

Installation

Unpack and inspect contents. Place the compressor on a stable surface.

Connect the air hose: Ensure the compressor is off before connecting.
Plug into a power outlet: Use a grounded outlet to avoid electrical hazards.
Check for leaks: After setup, turn on the compressor and check for any air leaks.

WARNING! Always ensure the compressor is turned off and unplugged during installation.

First-Time Setup

Power on the compressor; follow the setup instructions.

Set the pressure regulator: Adjust to the desired PSI for your application.
Test the compressor: Run it briefly to ensure proper operation.

CAUTION! Ensure the area is well-ventilated during operation.

Specifications

Model: Bostitch CAP2080WB
Tank Size: 6 gallons
Motor Power: 2.0 HP
Maximum Pressure: 150 PSI
Weight: 30 lbs
Dimensions: 18 x 18 x 18 inches
Pump Type: Oil-free

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel. Ensure the pressure gauge is visible for monitoring.

Safety Features: Automatic shut-off when maximum pressure is reached, thermal overload protection.

Connecting Devices

Connect air tools using the appropriate fittings for your air hose.

Ensure the compressor is off before connecting any tools.
Match the fittings to the air hose and tool.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check the compatibility of your tools with the compressor's specifications.

Operating the Compressor

Follow these steps to operate your Bostitch CAP2080WB air compressor.

Turn on the compressor using the power switch.
Adjust the pressure regulator to the desired level.
Connect your air tool and begin operation.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check and replace the air filter as needed.
Inspect hoses and fittings for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor. Always wear appropriate personal protective equipment.

WARNING! Keep the compressor away from flammable materials and ensure proper ventilation during use.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor does not start	Power supply issue	Check the power cord and outlet.
Low pressure	Leak in the system	Inspect for leaks and tighten connections.
Excessive noise	Worn components	Inspect and replace worn parts as necessary.
Tank does not fill	Faulty pressure switch	Replace the pressure switch if defective.

Reset: Unplug the compressor for a few minutes and then plug it back in.

Service: For assistance, contact Bostitch customer service.