Bostitch C50 Air Compressor Manual

The Bostitch C50 is a compact and powerful air compressor designed for a variety of applications, including inflating tires, powering pneumatic tools, and more. It features a 6-gallon tank, a maximum pressure of 150 PSI, and a lightweight design for easy portability. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, 150 PSI maximum pressure, oil-free pump, lightweight design, and easy-to-read pressure gauge.

Feature	Description
Oil-free pump	Requires no maintenance and provides clean air.
6-gallon tank	Provides ample air supply for various tasks.
150 PSI maximum pressure	Allows for efficient operation of pneumatic tools.
Lightweight design	Easy to transport and store.
Pressure gauge	For easy monitoring of air pressure.

Installation

Unpack the compressor and inspect for any damage. Place it on a stable surface away from moisture.

Connect the air hose: Ensure the compressor is off before connecting.
Plug into a power outlet: Use a grounded outlet for safety.
Check for leaks: Turn on the compressor and inspect connections.

WARNING! Always ensure the compressor is off before making any connections.

First-Time Setup

Power on the compressor and set the desired pressure using the pressure regulator.

Adjust pressure: Turn the regulator knob to set the desired PSI.
Test operation: Connect a tool and ensure proper functionality.

CAUTION! Do not exceed the maximum pressure rating of the compressor.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Power Source: 120V AC.
Weight: 30 lbs.
Noise Level: 68 dBA.
Pump Type: Oil-free.
Dimensions: 24 x 12 x 22 inches.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel.

Pressure Regulator: Adjusts the output pressure for connected tools.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

Ensure the compressor is off before connecting any devices.

Connect the air hose to the compressor outlet.
Attach the other end to the pneumatic tool.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

Follow these steps to operate the compressor effectively.

Turn on the compressor using the on/off switch.
Adjust the pressure regulator to the desired level.
Connect your pneumatic tool and begin operation.

WARNING! Do not exceed the maximum pressure rating.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank: Release moisture after each use.
Check for leaks: Inspect hoses and connections regularly.
Store in a dry place: Prevent rust and damage.

CAUTION! Always unplug before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor.

Always wear safety goggles when using pneumatic tools.
Keep the compressor away from flammable materials.
Do not operate in wet conditions.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check the power cord and outlet.
Low pressure	Leak in hose	Inspect and replace damaged hoses.
Noisy operation	Loose parts	Tighten any loose screws or components.
Tank won't fill	Faulty pressure switch	Replace the pressure switch if necessary.

Reset: Unplug and plug back in to reset the compressor.

Service: For support, contact Bostitch customer service.