Bostitch BTFP02028 Air Compressor Manual

The Bostitch BTFP02028 is a portable air compressor designed for a variety of tasks including inflation, nailing, and stapling. It features a 6-gallon pancake-style tank, a maximum pressure of 150 PSI, and a low noise level of 78.5 dBA for quieter operation. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, 150 PSI maximum pressure, oil-free pump, and lightweight design for easy portability.

Feature	Description
6-Gallon Tank	Provides ample air supply for various tasks
150 PSI Maximum Pressure	Allows for a wide range of applications
Oil-Free Pump	Requires less maintenance and is easier to use
Low Noise Level	Operates at 78.5 dBA for quieter performance
Portability	Lightweight design with a handle for easy transport

Installation

Unpack the compressor and inspect for any damage. Place on a stable surface.

Connect the air hose: Ensure it is securely attached to the compressor outlet.
Plug into a power source: Use a grounded outlet to avoid electrical hazards.
Check for leaks: Turn on the compressor and inspect for any air leaks.

WARNING! Ensure the compressor is placed in a well-ventilated area to avoid overheating.

First-Time Setup

Power on the compressor; follow the instructions for initial setup.

Set the pressure regulator: Adjust to the desired PSI for your application.
Test the compressor: Run it briefly to ensure proper operation.
Check the safety features: Ensure the safety valve is functioning correctly.

CAUTION! Always wear safety goggles when operating the compressor.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Noise Level: 78.5 dBA.
Power Source: 120V AC.
Weight: Approximately 30 lbs.
Pump Type: Oil-free.
Warranty: 1-year limited warranty.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel. Ensure all settings are adjusted before operation.

Pressure Regulator: Adjust to set the desired output pressure.

On/Off Switch: Use to power the compressor on and off.

Connecting Devices

Connect your tools using the air hose and appropriate fittings.

Ensure the compressor is off before connecting tools.
Match fittings to the tool's air inlet.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

Follow these steps to operate the compressor safely and effectively.

Turn on the compressor using the on/off switch.
Adjust the pressure regulator to the desired level.
Connect your tool and begin operation.
Monitor the compressor for any unusual sounds or behaviors.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check the air filter and clean or replace as necessary.
Inspect hoses and fittings for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor.

Keep the compressor away from flammable materials.
Do not operate in wet conditions.
Always wear appropriate safety gear.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	No power	Check power source and connections.
Low pressure	Leak in hose	Inspect and replace damaged hoses.
Excessive noise	Loose parts	Tighten all screws and fittings.
Tank won't fill	Faulty pressure switch	Replace the pressure switch if necessary.

Service: For further assistance, contact Bostitch customer service.