Bostitch Air Compressor 6 Gallon Manual

The Bostitch 6 Gallon Air Compressor is a portable and powerful air compressor designed for a variety of tasks, including inflation, nailing, and stapling. It features a 6-gallon tank, a maximum pressure of 150 PSI, and a high-efficiency motor that allows for easy start-up in cold weather. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating Instructions 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, 150 PSI maximum pressure, oil-free pump, lightweight design, and easy-to-read pressure gauge.

Feature	Description
6-Gallon Tank	Provides ample air supply for various tasks
150 PSI Maximum Pressure	Delivers high pressure for efficient operation
Oil-Free Pump	Requires no maintenance and reduces oil spills
Portable Design	Lightweight and easy to carry
Easy-to-Read Pressure Gauge	Allows for accurate monitoring of air pressure

Installation

Unpack and inspect contents. Place the compressor on a stable surface.

Connect air hose: Ensure the compressor is off before connecting.
Check oil level: Verify that the oil level is adequate if applicable.
Plug into AC power: Ensure the voltage matches the compressor requirements.

WARNING! Ensure all connections are secure and do not operate in wet conditions.

First-Time Setup

Power on the compressor and allow it to build pressure.

Set the desired pressure: Use the pressure regulator to adjust.
Connect tools: Attach the air hose to the tool you intend to use.
Test operation: Ensure the compressor operates smoothly and quietly.

CAUTION! Always wear safety goggles when operating the compressor.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Motor: 0.8 HP, oil-free.
Weight: Approximately 30 lbs.
Dimensions: 18 x 18 x 18 inches.
Power Source: 120V AC.
Operating Temperature: 50°F to 104°F.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel. Ensure the pressure gauge is visible for monitoring.

Safety Features: Automatic shut-off at maximum pressure, thermal overload protection.

Connecting Devices

Ensure the compressor is off before connecting any devices.

Match the air hose to the tool's inlet.
Secure connections to prevent air leaks.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks before starting work.

Operating Instructions

To operate the compressor, follow the steps outlined in the first-time setup section. Always ensure the area is clear of obstructions.

Power on the compressor.
Allow it to reach the desired pressure.
Use the connected tool as needed.

WARNING! Do not exceed the maximum pressure rating of the tools being used.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check and replace air filters as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Always follow safety guidelines when operating the compressor. Wear appropriate personal protective equipment and ensure the work area is well-ventilated.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check power cord and outlet.
No pressure build-up	Leak in the system	Inspect hoses and connections for leaks.
Excessive noise	Loose components	Tighten any loose screws or parts.
Overheating	Blocked air intake	Ensure air intake is clear of obstructions.

Service: For further assistance, contact Bostitch customer support.